Build Your Own 3D-Printed Desk Mount

Desk Clamp Base

Clamps to desks up to 60mm thick. The most popular base, fits any standard desk edge and holds firm without marking the surface.

Select a Colour

Wall Mount Base

Screw-in wall plate for permanent studio or office installs. Sits flat against any wall and accepts all FormRig arm segments.

Select a Colour

Grommet Base

Threads through your desk grommet hole for the cleanest possible cable management. Fits 40-80mm grommet openings.

Select a Colour

Short Arm (100mm)

100mm of compact reach, ideal for tight desk setups or when you just need a slight offset from the base.

Select a Colour

Medium Arm (200mm)

The most versatile length, 200mm puts your mic, camera, or tablet right where you need it for most configurations.

Select a Colour

Long Arm (300mm)

300mm of extended reach for monitors, overhead cameras, and situations where you need to span across a wide desk.

Select a Colour

Elbow Link 45°

A gentle 45° redirect. Perfect for angling a mic toward your mouth, or routing an arm around an obstacle.

Select a Colour

Elbow Link 90°

A sharp 90° turn for top-down camera arms, L-shaped rigs, and routing arms along the edge of a desk.

Select a Colour

T-Branch Link

Split one arm into two, mount your mic on one branch and your camera or light on the other, all from a single base.

Select a Colour

Straight Connector

Joins two arm segments inline to extend your reach without buying a new longer arm.

Select a Colour

Microphone Mount

5/8" thread adapter for any standard boom mic clip. Swing your mic into position for recording and back out of frame when you're done.

Select a Colour

Camera Mount

Universal 1/4"-20 thread compatible with DSLRs, mirrorless cameras, webcams, and action cameras.

Select a Colour

Tablet & Phone Mount

Adjustable grip for devices up to 13", phones, tablets, e-readers. Holds securely at any angle.

Select a Colour

VESA Monitor Mount

75×75 and 100×100 VESA compatible. Free your desk from a monitor stand and dial in the perfect height and angle.

Select a Colour

Ring Light Mount

Fits standard ring light thread and cold shoe adapters. Combine with a T-Branch Link to run light, mic, and camera from one base.

Select a Colour

FormRig Hardware Pack

Complete hardware pack, 5× screws, 5× washers, 5× nuts. Everything you need to assemble a full FormRig arm.

Select a Colour

FormRig Screw (5-pack)

5× custom 3D printed screws designed for the FormRig system. Printed in PETG, choose your colour.

Select a Colour

FormRig Washer (5-pack)

5× custom 3D printed washers. Printed in PETG, choose your colour.

Select a Colour

FormRig Nut (5-pack)

5× custom 3D printed nuts. Printed in PETG, choose your colour.

Select a Colour